Land plots

Reading a Ukrainian cadastral number and land cadastre extract before you buy

The seller sends a photo of an old cadastre extract and a long number. We take that number apart, show how to get a fresh extract yourself and point to the fields that tell you something is off.

10 min read
Banner for an article on reading a Ukrainian cadastral number and land cadastre extract

Short answer

A Ukrainian cadastral number has 19 digits in four groups: the cadastral zone (10 and 2 digits), the block (3) and the plot within the block (4). It identifies the plot but does not prove which village it is in. Anyone with a qualified e-signature can order a land cadastre extract; online it is issued at once and the 2026 fee is 0.05 of the subsistence minimum, about 166 hryvnias. Before a deposit, check area, designated use, land types, restrictions and owner.

Buyers who live abroad usually meet the land cadastre extract as a blurry phone photo from the seller, often a year or two old, with the line "everything is in there". It mostly is. The trouble is knowing where to look and what each line means for you as the buyer. This article takes the cadastral number apart digit by digit and then goes through the extract field by field, in the order we read it ourselves.

Everything below rests on two documents: the Law of Ukraine on the State Land Cadastre and the Procedure for keeping it, approved by Cabinet of Ministers resolution No. 1051. The official legislation portal was not reachable on 13 November, so we read both on the protocol.ua copy; links are at the end.

What the 19 digits of a cadastral number mean

The number has three parts separated by colons: the cadastral zone, the cadastral block and the plot number inside that block. The zone number itself is 12 digits with its last two split off by another colon, which is why you see four groups on paper.

XXXXXXXXXX : XX : XXX : XXXX

The four groups of a cadastral number under points 30 and 34 of the Procedure
GroupDigitsWhat it isWhat a buyer can take from it
First10Main part of the cadastral zone numberThe zone on the index maps; in older zones the opening digits often carry the code of the former district from the old KOATUU classifier
Second2End of the zone numberTogether with the first group it gives the full 12-digit zone
Third3Cadastral block inside the zone, up to 999Neighbouring plots usually share a block, so a neighbour's number helps you find yours on the map
Fourth4Plot number within the block, up to 9999Separates your plot from the one next door; one wrong digit is a different piece of land

The sentence that matters most sits in point 26 of the Procedure: a cadastral number does not show which administrative unit the plot belongs to. The 2020 reform redrew district and community boundaries, while plot numbers issued before it stayed exactly as they were. Read the village and community in the location field of the extract instead of guessing from the first digits.

When the number changes and when it stays the same

The law is clear on this. A new owner, a lease, an easement or a corrected record leaves the number untouched. A new number appears only when a plot is split or merged with another one, and the old number is then cancelled and never given to any other plot.

  • The number in the contract, in the State Register of Property Rights and in the cadastre should match to the last digit. The notary checks this too, but it is better to spot a mismatch before your deposit leaves your account.
  • If the seller's number finds nothing on the Public Cadastral Map, the usual reason is that the plot has since been split. Ask for the new number and the division documents, because what is for sale now is a different, smaller plot.
  • If the seller says there is no number yet, the plot is not registered in the cadastre. No extract can be issued for it, and it is too early to treat it as a building plot ready to buy.

How to order an extract yourself and what it costs

Any person or company can get an extract on a specific plot once identified with a qualified electronic signature or another high-assurance e-ID. The owner's consent is not needed, so there is no reason to wait for the seller to find a recent copy.

  1. Take the cadastral number from the seller's papers, or find the plot on the Public Cadastral Map through a neighbour's number.
  2. Order the extract online through the Public Cadastral Map or the State Geocadastre e-services, signing in with your e-signature. By law an electronic extract is produced in real time.
  3. Without an e-signature, apply at an administrative services centre (TsNAP) with your passport, or through a representative with a power of attorney. The law says a paper extract is issued on the day the application arrives.
  4. Decide whether you want the State Register of Property Rights data in the same extract. It costs an extra fee, and you can also order it separately.

Point 178 of the Procedure adds one more detail: an extract is valid for three months from issue. A photo of a year-old extract tells you what the plot looked like then. At the deal itself the notary is required by law to pull a fresh extract, and that is the one that will show whether anything has changed.

Field by field: what to read in the extract before a deposit

The land book behind the extract holds the cadastral number, location, boundary description, area, side lengths, coordinates of the corner points, designated use, land types, restrictions, any part under an easement or sublease, the normative valuation and the documentation all of this was entered from. This is how we go through those fields.

Fields of a land cadastre extract and what to check in each
FieldWhat to checkWhen to stop and ask
Cadastral numberSame in the contract, rights register and mapThe number is cancelled or the map shows another shape
LocationVillage, community, street address if anyA different village from the one you were shown
AreaSame as the listing and the title documentA gap of several hundred square metres with no explanation
Designated useLand category and type of use fit your plansA plot sold for a house carries an agricultural use
Land typesWhich types and how many hectares of eachOnly pasture or forest where you want to build
RestrictionsType, area and the document behind each oneA stream buffer, power line or gas pipe zone where the house would stand
Easement, subleaseWhich part of the plot and for whomA right of way for a neighbour across the middle
Normative valuationDate of the valuation, which drives the land taxAn old valuation with a new one on the way
Land management documentsWho drew up the project, when and on what basisThe plot was formed a few weeks ago and is already on sale
Owner and rightsWho owns it, any lease, mortgage or seizureThe owner on record is not the person signing

Area, coordinates and side lengths

Area in hectares looks dry, yet this is where a swap usually hides. On a slope, a plot of the same size can have a very different outline from the one you were walked around near the road. A surveyor can set out the corner coordinates and side lengths from the extract in one visit, and then you see where your land ends and whether a neighbour's shed sits on it. We covered how such disputes get settled in our piece on boundary disputes with neighbours.

Designated use and land types

These two fields are easy to confuse. Designated use says what the plot was granted for, for example building and maintaining a house. Land types record what is physically there: built-up land, arable land, hay meadow, pasture, forest. A plot with the right designated use that is recorded entirely as pasture can still be built on, though the project has to account for it. What each use code allows is set out in our guide to Ukrainian land use codes.

Restrictions and parts of the plot

In the mountains this field is rarely empty: streams, power lines, roads. Each restriction comes with its type, its area and a reference to the document it was entered from. If one covers the flat part of the slope where you pictured the house, work out how much usable land is really left. Water near a plot has its own article on riparian buffer strips.

Owner and property rights

Rights that arose after 1 January 2013 are kept in the State Register of Property Rights, not in the cadastre. An extract without register data can therefore show an earlier owner or no current owner at all, and that alone does not mean anyone is lying. Judge ownership from the register information, added to the extract or ordered on its own.

What to put next to the extract

The extract describes the plot as it was entered into the cadastre. Whether your particular house may go on it is decided by the community's planning documents, so take that question to the village or town council. The normative valuation in the extract matters for tax, not for the price you agree; our article on normative versus market valuation explains why.

If you are just starting to look, browse our land for sale in the Carpathians: once you have a plot's number, you can work through this article before you travel.

Frequently asked questions

Sources

This article is for information and is not legal advice. The law and the Procedure were read on 13 November 2026 on the protocol.ua copy because the official portal zakon.rada.gov.ua did not open that day. Article 41 was amended by Law No. 5020-IX of 14 October 2026; we did not check when those changes take effect. Confirm the current wording and the fee on official sources or with a notary.

Read next

Need advice on a specific property?

Tell us what you are looking for. We will shortlist options, check the documents and drive out to see the site with you.

Get in touch